Not sure how I screwed up the pin numbers. Write everything down and and still screw it up
I do have limit switches in series(N.C.) that is why they are on the same pin. They work properly, just need to add some more switches. I was thinking that I could set the home switches to stop movement but I need to add a limit on that end also.
I'm not close to the machine but I did look at the frequency before I left the shop and it was staying over 25k and the Time in Int was bouncing between +11 and +15.
In simulation it works fine. When running an actual cycle, you can watch the feed rate go up and down. So, I think it is something the computer is telling it and not with the drive or motors. Is it possible that it could be a computer problem? Processor speed? Amount of ram? Just throwing out all the options.
Sorry about sending the backup and not the actual XML. I thought the backup was what you were looking for. It will be Sunday before I can get the actual XML file.
I'm thinking about loading the 540 file from the Gecko site and see if that changes things.
Any other thoughts?