Does the peck drilling feature in lazycam work.  I'm having touble getting it to g83..when I post the to mach3 it show up as g81.

Thanks
Steve

Steve,
In the manual, page 42, I have noted that "G83 and G73 canned cycles are not functional" ....i am meaning they don't post and you get a G81 by default........ and I then go on to explain what to do to about it.
Since the whole manual was written based on experimentation, that truely may not be the case, but feel free to hack at it and see if there is something that would trigger it. I am done hacking......LC is the way it is.
RICH

Thanks Rich,

Manual?  I never new one existed.  Is there some where I might find one.  Atleast I don't have to keep trying every combination I can think of to get it to work.   Myself,  I am learning how G Codes work so I thought I was doing something wrong...   Only ate up about 6 hours trying to figure it out.   Again Thanks!

Steve

Steve,
A manual for LazyCam can be found in Members Docs. Merry Christmas.....and happy reading
RICH