Im a newbie, please help...
I drawing the charcter L and P in the Corel Draw and Export to Card with exp is : .DXF
when I using the LCam the pictuter very good :

but convert to the Mach3, the P no good :

please show me how to do fix it

sorry the link is fail :
http://me.zing.vn/apps/photo?params=/0o000000/album/photo-detail/id/1140974476
http://me.zing.vn/apps/photo?params=/0o000000/album/photo-detail/id/1140974477

Are you using a licensed version of Mach3?

Turn of splines in corel draw.

Graham
 

Thanks for your respond.
I just begin lean CNC, so using the demo of March3

I looking for splines but don't know, please show me How to do Off it, Thank a lot

You need to turn off splines in the Corel draw options within the DXF output.

The demo version of lazycam had a g-code limit of 50 lines and mach3 a limit of 500 lines.

Graham

Hix, I don't know splines, what splines and where 's it.
Whom know please me, Thx

hi to all guys out there i am new about cnc and i just finish my own cnc plasma table. i try to load a gcode that convert
from sheetcam and i fund out the size of my drawing is 10x bigger than the drawing. please help me, i don't know
where i got wrong and also i can't see the on/off of plasma

thanks

Hix, I don't know splines, what splines and where 's it.
Whom know please me, Thx

Whom know help me ...................