What would make the size of holes change during cutting????

Pages: « 1 2 Go Down

0 Members and 2 Guests are viewing this topic.

« Reply #10 on: December 02, 2010, 09:35:57 AM »

Hi Lulu,

It does the same thing no matter where you place the work on the table...? Can you post the Gcode?

Dan

Logged

« Reply #11 on: December 02, 2010, 09:45:08 AM »

Hi Lulu,

It does the same thing no matter where you place the work on the table...? Can you post the Gcode?

Dan

Hi Dan,

I'll post the G code later. Have an important meeting I have to attend. If not today, I will do it tomorrow.

LuLu

Logged

Pages: « 1 2 Go Up