Hello Guest it is April 20, 2024, 06:39:39 AM

Author Topic: Using Mach 3 Pulsing Engine  (Read 13074 times)

0 Members and 1 Guest are viewing this topic.

Re: Using Mach 3 Pulsing Engine
« Reply #10 on: April 07, 2015, 11:06:09 AM »
Thank each of you for your ideas.

There's another method, and that's to make a rectangular pocket, and along with stirling's suggestion to set the pulse rate.

Along the way, I also wrote an application to mess with the port bits, using C++ Builder.

...but the Servo Frequency Generator is the best.