I suppose the question is why and for what purpose do you want to use it ?
Tweakie.
I would like to use it if it's possible, to make a pin pulser at some rate, for the purpose of setting my Geckodrive 320 gain and damping pots, while using an oscilloscope.
The instructions (Mariss wrote them, I believe) show to set a pulse count of around 40 steps/second, and also control the direction pin at the same time, while adjusting the pots, to obtain a properly damped control.
If the pulsing engine is capable of doing that, and the software interface is known, then I can write the program to enable the pulse for each of my 3 axis step and direction pins.
Alternatively, if some of you could point me to a similar tool that allows pulse rate on a particular pin, while controlling another pin high/low, that would suffice.