Hello,
The motherboard on the computer I was using went bad, so I am switching Mach3 and VCarvePro 5 to a "new" used computer. The switch is like-for-like, I am going from a computer which ran Windows XP to a computer which runs Windows XP.
Our old computer's hard drive is A-OK, so I downloaded all the Mach3 and VCarvePro files I could find to a flash drive and then installed them on the new computer.
So far, I only have the Mach3 folder which was located in "Program Files" on the C:\ drive.
There are probably files I am not bringing from the old computer to the new one, so I would like to have the experts here advise me on what I am missing.