Hello Guest it is October 15, 2021, 06:05:32 PM

Author Topic: After I hit RUN...  (Read 1841 times)

0 Members and 1 Guest are viewing this topic.

After I hit RUN...
« on: October 03, 2010, 11:19:37 PM »
After I hit "RUN" my plasma cnc table goes to my Lead In starting point from my 0,0 point. This works great, but I would like my gantry to move at a slower rate to get to this point. Is it possible to have  this feedrate slower than the feedrate for the cutting? Is it possible to set this to a percentage of the actual feedrate? If so, please let me know where to set this.

Offline Hood

  •  25,838 25,838
  • Carnoustie, Scotland
    • View Profile
Re: After I hit RUN...
« Reply #1 on: October 04, 2010, 02:23:07 AM »
Use a slower feedrate in your code for the initial move, for example if the move in question is a G0 then Put a G1 with a F100 or whatever instead..