Hello all,
Here are a few pictures of my new milling vise. It is very much like the Sherline milling vise, only bigger. The idea behind it is so I can make pocket jaws to hold irregular shaped, multi-operation parts. The jaws can be flipped over to make more pockets. When I make a fresh set of jaws, I drill and ream two .125 holes for dowel pins. After pinning the jaws, I machine them together to be a matched set. This makes reloading the jaws extremely simple, and accurate. I like to machine a tramming hole on the stationary jaw. I also make jaws out of cast acrylic. it's cheaper, easier, quicker, and works just about as well.
Thank's for looking!
Ken