Hello Guest it is August 09, 2022, 09:44:38 PM

Author Topic: Harbor Freight 12X36 (not CNC)  (Read 3019 times)

0 Members and 1 Guest are viewing this topic.

Offline Sam

  • *
  •  987 987
    • View Profile
    • hillbillyhilton.com
Harbor Freight 12X36 (not CNC)
« on: July 31, 2010, 07:52:39 PM »
Work on the mill got put off another day, because I had an opportunity to get a small lathe. I didn't really want a small bench lathe, but the price was right, it was practically brand new, and it was a whole lot better than the other lathe I don't have. Oh well, "carpe diem" as they say. I did see a few sprinkles of aluminum chips, some carbide tipped tooling that had been sharpened wrong, and a couple other "tell tale" signs that somebody obviously didn't know what they were doing, and lost interest in a New York minute. The date says 2002, but the grease from the factory is still covering everything, and lots of stuff still has the rice paper around it. Not even a scratch on the back splash. If it turns out to be a halfway decent lathe, I might CNC it in the distant future. I see Ron Ginger has already converted one, and Rich done the Atlas. Now I know who to ask for any questions I might have.  ;D
"CONFIDENCE: it's the feeling you experience before you fully understand the situation."
Re: Harbor Freight 12X36 (not CNC)
« Reply #1 on: August 01, 2010, 10:51:11 PM »
12" by 36". Nothing wrong with that. Sometimes I wish I had a smaller one, Not what the wife says though. LOL.
Ed VanEss

Offline Tweakie.CNC

  • *
  •  8,928 8,928
  • Super Kitty
    • View Profile
Re: Harbor Freight 12X36 (not CNC)
« Reply #2 on: August 02, 2010, 02:38:19 AM »
As long as you use it to make bits for the Duke then that's OK with me  ;D

Nice buy Sam.