Dave,
Nice work! Everything loaded cleanly (after a couple of minor screw-ups on my part - failure to read directions). After I cloned a new set-up and copied in the appropriate config settings for my machine, everything seemed to run as advertised...
(I'm using the CandCNC BOB, and after I remembered to activate the CandCNC pugins, everything it was supposed to do also seemed to work).
I'm having two minor problems, which I suspect are not Screen set problems, but may be interaction issues between the CandCNC plugins and MachSTDMill:
1. When I hit the "go to Zero" button on the Run screen, the X&Y axes move simultaneously to zero, and then the z axis moves to its zero. (Obviously, not the desired sequence). Changes to the safe Z setting seem to have no effect.
2. On initial start-up, I always get the mach "Reset Command failed-Limit Switch Active" message. If I have Mach toggle the switches, and go through this sequence twice(??), everything functions normally for the rest of the session.
Any thoughts on these two things??
I've cut a couple of small parts without problems, other than the two noted above.
Again, the screens are great- clean and well organized. I'm really looking forward to using the probing functionality...
Ventuseu