Hi All,

I built a simple pendant with (2) three position rotaty switches for Axis select and Step select. I set them up (on PoKeys) as digital inputs on pins 6 thru 11. I have a single pushbutton, pin 5, selecting MPG Jog mode.  These all work fine as expected. I have an MPG wired up to my Pokeys pin 1 and 2.  I set up both the Encoder 1 and MPG #1 in 'Ports & Pins' to Port 10, Pins 1 for A and 2 for B. When I rotate the MPG, I get cycling on the 'IO Status' screen and the 'Encoder RAW Value' screen, but no physical axis cycling. I tried enabling "Enable Fast Encodors' Pins 2-3, 4-5 and 15-16' to no avail. Can anyone help?

Johnv

Hi!

Sorry for late answer. Recently there was a manual published on www.poscope.com

regards

Boris

also, Make sure you are in "MPG" Jog mode in Mach if your running a self made pendant.

i.e. hit the TAB key and look on the jog flyout, there is a button for cycle jog type, push it until the MPG led is on, then below that select what axis your jogging with it.

scott

Johnny,

You can find useful information here:

http://www.cnc4pc.com/Store/osc/index.php?cPath=40

http://www.cnc4pc.com/Store/osc/index.php?cPath=54

Arturo Duncan
http://cnc4pc.com