Hello Guest it is March 28, 2024, 06:06:44 AM

Author Topic: cutting out of line with the toolpath  (Read 5679 times)

0 Members and 1 Guest are viewing this topic.

Re: cutting out of line with the toolpath
« Reply #10 on: July 10, 2010, 09:44:50 AM »
I found that I had a screw that was not tight at a terminal strip.
Re: cutting out of line with the toolpath
« Reply #11 on: July 13, 2010, 01:56:02 PM »
thanks a lot...I will take a look at the terminals....so far the machine has settled down (since removing the anti virus..maybe it was just luck!)