Hello Guest it is October 14, 2019, 12:05:42 AM

Author Topic: Secondary machine coordinate position?  (Read 1178 times)

0 Members and 1 Guest are viewing this topic.

Secondary machine coordinate position?
« on: July 08, 2010, 10:04:26 PM »
If I am going to set up an auxiliary high speed spindle that is mounted offset from my primary mill spindle. Can I setup a secondary machine home position? I hope to controll this with a hardware switch that will know if I have the secondary spindle mounted?

My thinking is this might reduce potential problems while trying to use offset coordinates.

Regards