Hello Guest it is December 12, 2024, 03:33:44 PM
Profile Guest
« previous next »
Pages: « 1 2 3 4   Go Down

Author Topic: Is anyone else using E1P1 / E1P0 to switch output #1 ?  (Read 22305 times)

0 Members and 2 Guests are viewing this topic.

Offline BR549

*
  • 6,965 6,965
Re: Is anyone else using E1P1 / E1P0 to switch output #1 ?
« Reply #30 on: July 05, 2010, 12:48:56 PM »
HUM that is interesting. Art stated early on that the E1p0/1 was to be ONLY Used on a line by itself. If used on mixed line it would error out as bad code syntax error.

Logged

Offline BR549

*
  • 6,965 6,965
Re: Is anyone else using E1P1 / E1P0 to switch output #1 ?
« Reply #31 on: July 08, 2010, 08:35:15 PM »
TWEEKIE, Question on the E1p0(;-)   How are you generating your Gcode for laser???
Logged

Offline Tweakie.CNC

*
  • *
  • 9,274 9,274
  • Super Kitty
Re: Is anyone else using E1P1 / E1P0 to switch output #1 ?
« Reply #32 on: July 09, 2010, 01:30:18 AM »
The example I have been using was created using a Roland engraving program which outputs HPGL, this was then converted to GCode. Then I edit the Z moves to the E1P0....

Tweakie.
Logged
PEACE

Offline BR549

*
  • 6,965 6,965
Re: Is anyone else using E1P1 / E1P0 to switch output #1 ?
« Reply #33 on: July 09, 2010, 05:38:40 PM »
OK Thanks, I found a slight M5 delay in sheetcam gcode output and was wondering if you were useing that.

Logged
Pages: « 1 2 3 4   Go Up
« previous next »