Hello Guest it is June 05, 2023, 07:08:58 PM

Author Topic: Impatient question  (Read 2802 times)

0 Members and 1 Guest are viewing this topic.

Impatient question
« on: October 05, 2006, 08:51:08 PM »

I got X & Y hooked up and just couldnt wait to make the servo's move .. hehe
They Move !!!   Woot.

But when I run a test GCode they move Sooooooo  Sloooow ..
I tweaked a few things in motor tuning but it didnt make a Diff ?
What am I missing here ?  ???

Offline Chip

  • *
  •  2,055 2,055
  • Gainesville Florida USA
    • View Profile
Re: Impatient question
« Reply #1 on: October 05, 2006, 09:10:20 PM »
Hi, Yodawill2000

On your Program Run Screen find feedrate coll um, in the feedrate window dose it say 6.0, default setting, Click on the window enter 50

and hit Enter key, should say 50 now, try your code.

In your Gcode F for Speed with g01, g02, g03,.......  G01 x1 y1  F25.

Hope this Helps, Chip
Re: Impatient question
« Reply #2 on: October 05, 2006, 09:37:05 PM »
Thanx .
The GCode I ran was the "Test Gcode" that loaded with Mach3.
Maybe it was set slow .
I'll check it out tomm. when I get off work.
Just tickled to pulse the servo's finally  ;D

Kewlness .

The rapid Jog was enough to make me Grin Ear to Ear.
Those Pittman's were humming right along !