Hello everyone,

Recently the computer died that ran my Super X3 using Mach3 controller...

Swapped computers... loaded Mach3 and Lazycam again... everything seems to be moving fine... EXCEPT... my old programs run in reverse...
Might be OK but Z + is going down.. so that would be a problem...

Is there some config / function config that i have to change???

I'm having difficulties locating something that will help...

Any help is very grateful

Thanks

Ian
MotoGems.

You either have the Dir active state set wrong for Z, you will find it Config menu, Ports and Pins, Motor Outputs page
Or you need to change the Reverse setting on Config menu, Homing and Limits page.
Hood