Vogavt,
Example One:
Spend $20 and buy a program called Wrapper as it will do all the converting for you and save you from mistakes.
Example Two:
Yes, the rotary is set up as Angular, then the code is sort of like:
G********* ( DRILL HOLE / CANNNED CYCLE)
G0 A90 ( ROTATES THE A AXIS 90 DEGREES )
Repeat above if in Incremental mode
Have a look in the Tool Box as there is a canned drill cycle for the lathe which can generate all the code.
There is a read me file in the file explaining how to install and use.
Example Three:
In another thread there was a suggestion, but, I would recommend going back to using the lathe with a conventional motor
using an index. See Threading on the Lathe in Members Docs.
You need a seperate profiles for rotary when using it as Rotary or linear or for that matter slaving it.
RICH