Hello Guest it is September 21, 2019, 12:07:40 PM

Author Topic: Motion Controller to Mach3 Problems  (Read 11521 times)

0 Members and 1 Guest are viewing this topic.

Offline Tweakie.CNC

*
  • *
  •  7,911 7,911
  • Super Kitty
    • View Profile
    • Tweakie.CNC
Re: Motion Controller to Mach3 Problems
« Reply #20 on: November 19, 2009, 08:38:58 AM »
Suggest you wait until you have your new BOB before going any further. Have patience my friend.

Tweakie.
Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.
Re: Motion Controller to Mach3 Problems
« Reply #21 on: July 07, 2010, 09:17:23 AM »
Hi to all
I have just received my BOB and have wired up the motors and tested all is working so far, I would like to thank you all for the advice you have given so far I will be asking more questions in the next few day's.
Thanks Again ;D