Hello Guest it is May 03, 2025, 07:02:04 PM
Profile Guest
« previous next »
Pages: « 1 2 3   Go Down

Author Topic: Motion Controller to Mach3 Problems  (Read 22090 times)

0 Members and 1 Guest are viewing this topic.

Offline Tweakie.CNC

*
  • *
  • 9,284 9,284
  • Super Kitty
Re: Motion Controller to Mach3 Problems
« Reply #20 on: November 19, 2009, 08:38:58 AM »
Suggest you wait until you have your new BOB before going any further. Have patience my friend.

Tweakie.
Logged
PEACE

Offline overdrive915

*
  • 11 11
Re: Motion Controller to Mach3 Problems
« Reply #21 on: July 07, 2010, 09:17:23 AM »
Hi to all
I have just received my BOB and have wired up the motors and tested all is working so far, I would like to thank you all for the advice you have given so far I will be asking more questions in the next few day's.
Thanks Again ;D
Logged
Pages: « 1 2 3   Go Up
« previous next »