I re-did the whole Layout in LazyCAM and made 3 seperate g-code .tap files.
One for the HERCERK, one for the 1st and one for the ABALONE.
Then, ran it all seperatly .
And, I didn't go that deep (Z axis).
Finally it didn't "Jump"..
But, It's little off-center.
Or, that, as the machine engraves, the fonts get bigger as they move to the right end fonts.
The font is slightly larger, thereby, increasing the space between the top of the Font and the border.
It happen before.
I have another Cap completed, with the engraving that shows that "Effect".
Thanks for your time Guys..
I don't know if the problem will occur again.
Alton