Hi Brian
Finally it looks like my logging problems solved. My firewall and cookies seem to have been the problem. Well back to our thread....
Yes the file save works very nice.
The following is a thread I posted on the Yahoo group. I haven't got a answer yet, so I will post it here as well.
I'm busy doing a wizard that consist of about nine (9) pages.
My current setup equals Mac 3 Lathe ver 00.46. Diameter mode.
On page three (3) I do a facing cut. I have a ticker set to warn of
a toolcrash........
If XStart < = StockDia then
setTicker 20, "******WARNING*****"
Exit Sub
End If
setTicker 20, ""
Diacheck = 1
If IsDiameter() = 1 Then
XEnd = XEnd / 2
XStart = XStart / 2
DiaCheck = 2
End If
When stepping into the program with VBScipt editor and moving the cursor over the following ,This is the value being displayed
XStart Value = 51 StockDia = 48
Diacheck = 2
On this page everything works fine without any VB errors.
On page 5 I've got a similar setup for a OD Cut.
I've got the same ticker setup with the same values, but on this page I get the ticker warning. In trying to solve this problem I ran
this script over and over in the VB Script Editor. I found that the value for diacheck gets displayed as 1 and then all X Values are
halved. This readings is intermediate, but I always get the same
ticker warning.
This is what brought up the Art Code 9991 error.
During the whole testing process nothing on my side gets altered or changed .All Mach3 setup values stay the same.It looks like the Diameter mode gets changed on the inside of Mach or something.
Hope you can help me with this.
One other thing........Will it be possible to pop up a warning box where the user can choose to carry on or abort instead of the ticker that just aborts the process. A scenario comes to mind for internal turning where you can turn inside the chuck body past the safe zone for external turning.
Thanks for all your help.
Regards
Deon