Hi all,
I was cutting a guitar body out of a test blank of pine when I turned the blank over after cutting the back, it was running the contour cleanup and it turned right and plowed into the body ruining my day and the blank.
I checked the gcode and didn't see anything wrong. So I wnet over that spot cutting air and it didn't do it. The only error I saw in Mach was the feed rate red light was blinking. It stopped moving. The .5 endmill was about 1.5" down when it happened.
I have no idea how to troubleshoot this, other than throw another blank on there and let er rip again.
Any ideas?
Here it is cutting the back.
http://www.youtube.com/watch?v=ra4amnO6L8g