let me start by saying that Ive learned alot so far. but Ive never been good at new languages. that being said. Is there a list somewhere that can give me definitions of what the status bar is trying to tell me when there is a bad line of code. currently I am staring at a line of code that I have gone over time and again and I cannot find the problem. Ill lay it out for you
current tool position is
X-.26 Y2.65
in G01 basolute mode
the line I get an error on is
G02 X.25 Y3.16 I.25 J2.65 now the error message sais" radius to end of arc differs from radius to start".
now Ive done the math a few times here and I com up with a radius of .51 for start and finish coordinates.
any thoughts out there. maybe my math is bad but you know how when you been working a while the numbers start to move on there own.
thanks