Hello Guest it is March 29, 2024, 05:14:28 AM

Author Topic: Possible wrong settings? or hardware?  (Read 8547 times)

0 Members and 1 Guest are viewing this topic.

Offline Chip

*
  • *
  •  2,055 2,055
  • Gainesville Florida USA
    • View Profile
Re: Possible wrong settings? or hardware?
« Reply #10 on: September 23, 2006, 10:50:33 PM »
Hi, Twin Staged

Did you clik on APPLY, then ok.

Chip
Re: Possible wrong settings? or hardware?
« Reply #11 on: September 24, 2006, 02:47:38 AM »
yes and all the pin numbers stayed where i put them on the restart.  It doesnt make sense to me why it didn't affect the proper axis.

Offline Chip

*
  • *
  •  2,055 2,055
  • Gainesville Florida USA
    • View Profile
Re: Possible wrong settings? or hardware?
« Reply #12 on: September 24, 2006, 03:00:49 PM »
Hi, Twin Staged

Post your pin # x,y,z,a, as thay appear in Config, Ports Pins, Motor Outputs and which axis moves when you jog x,y,z.a.

Thay still must be incorrect.

Thank's Chip
Re: Possible wrong settings? or hardware?
« Reply #13 on: September 27, 2006, 06:27:00 PM »
right now my  i have:

    Step     Dir
X     8       9

Y     4      5

Z     2       3

A     6       7

When i Jog X my Z moves
when I jog Z my A moves
when i jogY my Y moves
when i jog A my Xmoves

Offline Chip

*
  • *
  •  2,055 2,055
  • Gainesville Florida USA
    • View Profile
Re: Possible wrong settings? or hardware?
« Reply #14 on: September 27, 2006, 09:09:21 PM »
Hi, twin staged

Click on Config, Ports and Pins, Motor Outputs, enter the following  info. below, then Click on Apply then OK.

Now Reset, Jog all Axis's to check if Ok, Exit Program and Restart, If it doesn't reload the new setting's, about the only thing that could be

bad is your XML file is write protected.

    Step     Dir
X    6       7
 
Y    4      5 

Z    8       9

A    2       3 

If this docent please post your Mach3Mill.XML file

Thank"s Chip