Hello Guest it is March 28, 2024, 09:05:36 PM

Author Topic: cnc4pc multifuncion cnc board  (Read 3977 times)

0 Members and 1 Guest are viewing this topic.

cnc4pc multifuncion cnc board
« on: January 07, 2010, 05:04:48 PM »
Hallo
i have a cnc4pc multifuncion cnc board C11 can some whane tel me wat i have to use for driver to de steppers  I use the t x-y As   Japan Servo KH56QM2-951
Z As  23LM-co77-02v  what is the best option to use  i think this wil be ok  driver MSD-32-2.5?

GR Jan

Re: cnc4pc multifuncion cnc board
« Reply #1 on: January 08, 2010, 03:19:53 PM »
No one hoe have a answer for me wat is the best combination for the c11 board
Re: cnc4pc multifuncion cnc board
« Reply #2 on: January 08, 2010, 07:02:03 PM »
You need Stepper drivers?

Look at Gecko's.
http://www.geckodrive.com/

Offline Hood

*
  •  25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: cnc4pc multifuncion cnc board
« Reply #3 on: January 08, 2010, 07:18:22 PM »
Maybe give a link to the drives you mentioned as most probably dont know what MSD-32-2.5 are, so hard to say if they will do.
Hood
Re: cnc4pc multifuncion cnc board
« Reply #4 on: January 09, 2010, 08:01:04 AM »

Offline Hood

*
  •  25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: cnc4pc multifuncion cnc board
« Reply #5 on: January 09, 2010, 08:09:58 AM »
The first one should work ok but its borderline  on current and I would tend to go for the bigger one if it was me.
Hood