I am trying to make a Chinese checker board for my wife. I created the DXF file with all 121 holes. The holes are indicated with .125 D circles. When I load the file I click Drill rad circles and choose .3 and all 121 holes turn red. I then click on drill sel circles. In the layer tab I chose drill cycle and the proper hole depth etc. There are 120 chains shown so it looks like I have all 121 holes. When I post, the TAP file only has about 40 holes. What am I doing wrong? I need helps ASAP so I can complete this gift in time for Christmas.
Thanks
Vince