Hello Guest it is January 23, 2020, 12:41:11 AM

Author Topic: Does CNC Zone really exist?  (Read 2554 times)

0 Members and 2 Guests are viewing this topic.

Offline Fastest1

*
  •  927 927
  • Houston, TX
    • View Profile
Does CNC Zone really exist?
« on: November 29, 2009, 10:13:04 AM »
Apparently I must have pissed off someone there as they wont send me an activation letter. I have tried thru all 3 of my email addresses and nobody ever reponds. I did get a username and password, both of which are recognized but wont let me post. The site always refers to an activation letter that is never sent. I am not the only 1 with the problem judging from the fact that they have at least 1 thread stickied to the top of the forum about how to enter. I never have problems on the other sites, everyone elses activation letters got/get thru fine. Are any of you active there?
I want to die in my sleep like my grandfather, not like the passengers in the car! :-)

Offline Sam

*
  • *
  •  988 988
    • View Profile
    • hillbillyhilton.com
Re: Does CNC Zone really exist?
« Reply #1 on: November 29, 2009, 11:14:26 AM »
I would say 95% or more of us are members there. The responses are automated systems, I would presume.
After a quick look there, I see this thread...http://www.cnczone.com/forums/showthread.php?t=32641 so if all else fails, you should contact Paul.
There may be a "resend verification email" in your user control panel. Might be worth a shot trying that.
"CONFIDENCE: it's the feeling you experience before you fully understand the situation."

Offline ger21

*
  • *
  •  6,291 6,291
    • View Profile
    • The CNC Woodworker
Re: Does CNC Zone really exist?
« Reply #2 on: November 29, 2009, 01:18:18 PM »
Check your spam filter. If you still  can't get in and can't get ahold of Paul, PM me with your email address and I'll get it to Paul. I'm one of the main moderators there, and yes, it does exist. There's almost 140,000 members.
Gerry

2010 Screenset
http://www.thecncwoodworker.com/2010.html

JointCAM Dovetail and Box Joint software
http://www.g-forcecnc.com/jointcam.html