Hi, All
I did see in the manual that the "%" or "\\" and "()" should be used for Comment's and such.
In the End Shouldn't some of these be rejected or load of a file be halted as an Error.
10.5.5 Comments and Messages
A line that starts with the percent character, %, is treated as a comment and not interpreted
in any way.
Printable characters and white space inside parentheses is a comment. A left parenthesis
always starts a comment. The comment ends at the first right parenthesis found thereafter.
Once a left parenthesis is placed on a line, a matching right parenthesis must appear before
the end of the line. Comments may not be nested; it is an error if a left parenthesis is found
after the start of a comment and before the end of the comment. Here is an example of a line
containing a comment: G80 M5 (stop motion)
An alternative form of comment is to use the two characters // The remainder of the line
is treated as a comment
Comments do not cause the machining system to do anything.
A comment that is included in parenthesese, contains a message if MSG, appears after the
left parenthesis and before any other printing characters. Variants of MSG, which include
white space and lower case characters are allowed. Note that the comma which is required.
The rest of the characters before the right parenthesis are considered to be a message to the
operator. Messages are displayed on screen in the "Error" intelligent label.
Thanks, Chip