Gentlemen,
I was reading through a bunch of posts, but did not find any similar question, so I hope some of you may have some good ideas regarding my issue.
My first challenge is this one:
I need to process a gcode-file step per step, depending on an input signal.
The content of the file only controls the z-axis while a sensor mounted to the x axis delivers the pulses.
This does not have to happen very fast.
The second challenge:
These pulses come in constantly, but the code shall not be executed constantly. What needs to happen is this:
I want to push a button (lpt input), after that the gcode of file 1 shall be executed (depending on the pulses, step per step, line by line) unless I push the button again.
Now MACH shall place x at a certain point and load another file.
At this point I will move the workpiece around manually.
When I push the button again, the show shall repeat.
Has anyone ideas ?