Hello Guest it is May 11, 2021, 04:19:25 PM

Author Topic: Spindle setup  (Read 1685 times)

0 Members and 1 Guest are viewing this topic.

Spindle setup
« on: September 11, 2009, 11:03:45 AM »
Dear All,

I just brought Chinese made BOB.

   It have those pins(+12V, VCC, NC,NC ,DIR, PWM, GND ) at the board. I can not get a 5V as usual to control the SS relay.  How do i do? I m using Probotix previously.

After that,i thought is about should using PWM, which i never use this before.So i brought the motor driver(attched user manual)to control relay or speed. I had Try with some settting which i learn form Forum. But it cannt work.

I wish somebody are willing to help me.