I have really been trying to get this working. I'm at the point where I might try a different control software.
Here are some screen shots of what I have.
Firstly LC with DXF imported and all steps followed.
Second, the exported g-code in NCPlot 1.2
Third, the Mach3 screen of the same g-code.

Maybe someone can load my g-code and tell me if it is doing the same on there computer.

Just treid your gcode and it looks good here (I know my colors on the toolpaths are different as I have them set that way).

Not sure why Mach 3 is acting that way for you though, what version are you running and is it registered/paid for?

Dave

It is a demo, the demo has a 500 line limit and I was think I could route one line (up to 500) at a time. I think it will display the complete file but only route up to the 500 line point right?

No, it'll only display 500 lines of code in the toolpath window.

Try breaking the .dxf into separate lines of text, and saving each line as it's own .dxf

oh well that is probably the whole problem then.
Very good I will give that a shot.
Thanks for all your help.

how long to get a licence key if I order it tonight?

I hope the Licence team works on Sunday

Thanks for the file Scott.
Other than the Lazyview: OpenGL error when I press the button "Mach3 load" I can now see the complete file in Mach3. I post the file using the OutPut menu in LazyCAM and it works that way.

Thanks
Brent