Hello Guest it is July 17, 2026, 03:59:31 PM
Profile Guest
« previous next »
Pages: « 1 2   Go Down

Author Topic: Setting Tool Length Offsets....  (Read 21803 times)

0 Members and 2 Guests are viewing this topic.

vmax549

*
Re: Setting Tool Length Offsets....
« Reply #10 on: July 27, 2009, 10:37:05 PM »
RAY the T# calls the tool into the holding QUE (selected tool) THe M6 then sets the T# as the (CurrentTOOL) then calls the M6start macro. THe offset has NOT been applied yet.

(;-) TP
« Last Edit: July 27, 2009, 10:48:21 PM by vmax549 »
Logged
Pages: « 1 2   Go Up
« previous next »