Hello Guest it is April 26, 2025, 01:10:51 AM
Profile Guest
« previous next »
Pages: « 1 2   Go Down

Author Topic: Setting Tool Length Offsets....  (Read 13242 times)

0 Members and 1 Guest are viewing this topic.

vmax549

*
Re: Setting Tool Length Offsets....
« Reply #10 on: July 27, 2009, 11:37:05 PM »
RAY the T# calls the tool into the holding QUE (selected tool) THe M6 then sets the T# as the (CurrentTOOL) then calls the M6start macro. THe offset has NOT been applied yet.

(;-) TP
« Last Edit: July 27, 2009, 11:48:21 PM by vmax549 »
Logged
Pages: « 1 2   Go Up
« previous next »