Ok, I am about 95% of the way there (I think!
). Last night I ran my first live test - tool in the router, router on, and workpiece (foam) on the table. I managed to run three small jobs and it worked! However, leading up to that, I spent about an hour in frustration, some of which I did figure out.
What I need help with is the measurement system. When I set Mach3 up, I just instinctively chose inches since it's what I am used to. I am using metric for most of the parts I am designing though. So, if I design a part in metric and then load the gcode into Mach, do I need to switch Mach to metric? If so, I assume I do this on the Settings tab and not through the config screen (heard that in the video tutorial).
Should the DRO's reflect the measurement system of the job or will they always show inches. Like I said, I did get three small jobs to run, but afterwards, I had a moment of "ok, how did I do that?".
Thanks!
Dave