Hey,
I am trying to home my z axis on my positive limit switch, but for some reason when it hits the switch, the instant it moves off it goes right back up again into the switch. I left it for a minute or two and it continued to bounce on and off the limit switch with no signs of slowing down or stopping. The thing that gets me is that when I home on the negative z lim switch, it works perfectly. None of the other limit switches are behaving this way either, only the z+. I would say that it is almost like it is looping the homing function for z. Also, the Reset button on Mach doesn't stop it. I need to turn the servo off, cut the power or close Mach altogether.
Has anyone else had this problem?
Regards,
Tyler