Hello
Just bought the Newfangled Solution Wizard.
I'm very pleased with it, but I have some annoying things:
First of all, each time I genereted the GCode and go the the mach run screen, the system is in reset. I whave to click the reset button to get it out of reset.
WHy is that? Can I avoid this?
Second, when used some of the NFS wizards and when I want to return to the Wizard to make an change (go last used Wizard), I have to click thru all selection menus again before getting at the last used Wizard.
I would like to return the the laters used Wizard immediately.
Third. I read somewhere here in the forum that a Z-start parameter for the hole drill wizard(s) would be added soon (in a few days). That was in februari and but there is no such parameter yet.
Or do I have to uload some upgrade?
I hope a lot of usefull Wizard will be added in the near future!!!