The game controller was installed in this order,,,
I did not install the software that came with it.
I plugged it in (usb)
"Found new hardware",, recognized it by name and said it was ready to use.
I ran keygrabber, chose it for use, set the keys.
To enable it, I must run keygrabber then run mach (mill or turn) from keygrabber.
It ran fine for many hours. but,, yep,, a glitch could always be introduced...
I might could find another keyboard,, (ps2 type,, easy to find since usb) But,,, I wonder, is there even a hotkey to run the gcode when pressing "post code" button,,, without previewing it?
In my opinion I would NEVER want to do that.... hmmmm.... this is an odd one, for sure.
I appriciate your attention to this Hood,,,
Last resort is to reinstall mach3,,,,, Is there a way to just reinstall, or copy wizards over? Maybe manually replace the turn wizard folder from office PC to shop PC..?
Couldn't hurt I guess...