Hello Guest it is October 04, 2022, 06:48:24 PM

Author Topic: Need help with 4th axis continuous motion code  (Read 21622 times)

0 Members and 1 Guest are viewing this topic.

vmax549

*
Re: Need help with 4th axis continuous motion code
« Reply #20 on: May 30, 2009, 01:03:00 PM »
I don't believe it was about typing arrors but more so the cocky attitude.

(;-) TP
Re: Need help with 4th axis continuous motion code
« Reply #21 on: May 30, 2009, 01:27:53 PM »
Your question as given was answered as best as possible. Had your question been accurate the answers would have been different.
Given the tolerances you posted, your part is a failure. Using the called tolerances, you made a good part. If you can't see the difference, .
« Last Edit: May 30, 2009, 08:17:23 PM by RICH »
Re: Need help with 4th axis continuous motion code
« Reply #22 on: May 30, 2009, 03:23:11 PM »
I think you guys are a little harsh on TT350........
As I see it he made a reasonable question and said he was sorry for the typos. Can't we be a little more relaxad here? After all we dont compete with each other in here, we are here to ask questions and share information.

Offline RICH

*
  • *
  •  7,428 7,428
    • View Profile
Re: Need help with 4th axis continuous motion code
« Reply #23 on: May 30, 2009, 08:21:55 PM »
Hi All,
Just modified some verbage in the posts. Didn't care for girts when i lived on the other side of the Mason Dixon LINE and frankly don't like grits used in way said. We are above it.
SO KNOCK IT OFF OR THE WHOLE POST WILL GO!
Have fun.
RICH  ;)

Offline docltf

*
  •  354 354
    • View Profile
Re: Need help with 4th axis continuous motion code
« Reply #24 on: May 30, 2009, 09:36:10 PM »
good to see you got your part worked out TT and welcome to the forum. what make is the rotory you are using for the 4th.

bill

Offline TT350

*
  •  113 113
    • View Profile
Re: Need help with 4th axis continuous motion code
« Reply #25 on: May 30, 2009, 09:51:02 PM »
good to see you got your part worked out TT and welcome to the forum. what make is the rotory you are using for the 4th.

bill



Hi Bill

It's the 8" model that I bought with my Tormach.