Hello Guest it is March 29, 2024, 01:17:35 AM

Author Topic: Problem configuring NC Pod  (Read 19309 times)

0 Members and 1 Guest are viewing this topic.

Re: Problem configuring NC Pod
« Reply #10 on: May 11, 2009, 02:12:07 PM »
Hi,

thanks for your advices.

There is "Deskpod.dll in C:\Mach3\PlugIns. Is that OK ?

If it does, it was automaticaly done by installing ncpod driver.

In "C:\Mach3\PlugIns\NC-Pod USB Drivers" there is ncpod.dll ; ncpod.sys and ncpod.ini
If I put ncpod.dll in C:\Mach3\PlugIns an error occur.


Regards

Freddy

Re: Problem configuring NC Pod
« Reply #11 on: May 13, 2009, 05:11:43 PM »
Hello,

The communication between mach3 and NCPod is finaly OK !!

Now I have problem to setup motors.

Is the configuration below seems ok? (i don't know what pins to put in this array)





Regards
Freddy