Hello Guest it is March 28, 2024, 11:58:26 AM

Author Topic: MachTurn wizards  (Read 12646 times)

0 Members and 1 Guest are viewing this topic.

Offline RICH

*
  • *
  •  7,427 7,427
    • View Profile
Re: MachTurn wizards
« Reply #10 on: September 27, 2009, 03:55:41 PM »
Ian,
When in Mach Turn just click the Wizard tab at the top of the screen and select the threading or the turning.
RICH
Re: MachTurn wizards
« Reply #11 on: June 21, 2010, 04:28:00 PM »
When in Mach Turn just click the Wizard tab at the top of the screen and select the threading or the turning.

Hi,

Where can I find some instruction on using the Turn wizard?

Half the time I put a value in, it sets it back to zero with no error message or explanation.

Do I need to be a Psychic to use them?

Ramsey

Offline RICH

*
  • *
  •  7,427 7,427
    • View Profile
Re: MachTurn wizards
« Reply #12 on: June 21, 2010, 05:25:21 PM »
Ramsey,
There are no instructions.
So try it with simple / even numbers of input so you can check the posted g code.
I would recommend you set your config for radius and reversed arcs unchecked.
Make a few notes as you go along.....

RICH
Re: MachTurn wizards
« Reply #13 on: June 21, 2010, 05:44:51 PM »
also, you must hit the ENTER/RETURN key after each entry or it wont stick.