Hello Guest it is April 19, 2024, 03:11:51 AM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: motor tuning  (Read 2854 times)

0 Members and 1 Guest are viewing this topic.

Offline keithmech

*
  • 100 100
    • View Profile
motor tuning
« on: February 15, 2009, 06:09:11 PM »
well this is not really about tuning but I reinstalled mach 3 when I
added a ss to my lathe.Now there is nothing when I try to do the motor tuning.
ie  conifg-motor tuning- nothing pops up?
Why?
Logged

Offline HimyKabibble

*
  • 1,687 1,687
    • View Profile
Re: motor tuning
« Reply #1 on: February 15, 2009, 06:21:35 PM »
Try re-installing Mach, but don't install the SS plug in.  Does it work then?

Sounds like Mach just didn't install properly.  What version are you using?

Regards,
Ray L.
Logged
Regards,
Ray L.

Offline keithmech

*
  • 100 100
    • View Profile
Re: motor tuning
« Reply #2 on: February 15, 2009, 08:23:30 PM »
well I had tried a couple of instal/uninstalls but nothing, thats why I posted.
But i guess I must of stood just right because the last time was the one to make it work.
Logged
Pages: 1   Go Up
« previous next »