Hello Guest it is April 19, 2024, 08:42:34 AM
Profile Guest
« previous next »
Pages: « 1 2 3 4   Go Down

Author Topic: MachTurn wizard problem  (Read 17045 times)

0 Members and 1 Guest are viewing this topic.

Offline Graham Waterworth

*
  • *
  • 2,672 2,672
  • Yorkshire Dales, England
    • View Profile
Re: MachTurn wizard problem
« Reply #30 on: February 22, 2009, 04:02:34 PM »
 :)  8)

Graham
Logged
Without engineers the world stops

Offline N4NV

*
  • 398 398
    • View Profile
Re: MachTurn wizard problem
« Reply #31 on: February 22, 2009, 09:49:04 PM »
Here is the part with the flute cut in it and the bottom milled.

Vince
Logged

Offline RICH

*
  • *
  • 7,427 7,427
    • View Profile
Re: MachTurn wizard problem
« Reply #32 on: February 22, 2009, 10:49:23 PM »
So how manny parts to go Vince?
You know, this stuff can become addictive.
Lookin good.
RICH
Logged

Offline N4NV

*
  • 398 398
    • View Profile
Re: MachTurn wizard problem
« Reply #33 on: February 23, 2009, 09:43:32 AM »
Quote from: RICH on February 22, 2009, 10:49:23 PM
So how manny parts to go Vince?
You know, this stuff can become addictive.
Lookin good.
RICH

I'm about half way.  Most of the hard parts are done.  Lot's of little things to make on my taig lathe then the flywheel.  I have been trying to make one part a day, but in reality get one done in three days.  I have a niece that has been visiting to I have spent a lot of time showing her the sites.  The pictures are where I am at and a finished Miser engine.

Vince
Logged
Pages: « 1 2 3 4   Go Up
« previous next »