.I made up a one line brain that was to turn on the spindle
with a 5 sec delay as a test.I found that:as soon as the spindle is started
the relays on my breakout board would close.I turned off the brain
and on the spindle setup added a 5 sec delay.This did nothing.
I then turned off the outputs on the ports /pins for the spindle start.
The spindle would still run.I then changed the port and pin numbers to something
stupid ,still worked.
Is there something in the xml file for my Bob Campbell breakout board that is doing this?
I just added a Smooth stepper, might this be the cause?
.Maybe use relays not connected to the breakout board?