Hey all, Using mach 4. my gcode is in metric, my machine setup units and units mode is in metric. But sometimes when I go to jog using the keyboard in increment mode I set it to say 1mm but the machine moves 1inch. which can be quite scary when not expected and near something!
I close and re-open Mach 4 and its back to normal.
Is this a known problem? or any ideas what could be causing it?
Anything I could try/check to nut it out?
Now im in the habit of always testing it out first in the direction away from my stock to make sure its in metric but I should not have to