Hello Guest it is May 10, 2025, 08:38:46 PM
Profile Guest
« previous next »
Pages: « 1 2   Go Down

Author Topic: Configuring steps per unit and units per in Mach 3 - can anyone help?  (Read 15350 times)

0 Members and 1 Guest are viewing this topic.

Offline owilba

*
  • 4 4
Re: Configuring steps per unit and units per in Mach 3 - can anyone help?
« Reply #10 on: December 31, 2013, 03:02:56 PM »
when moving  X- 16.0000...it (X) moves one inch.....how to re-configure !??? I have above system , but in inches......
Logged

Offline Hood

*
  • 25,835 25,835
  • Carnoustie, Scotland
Re: Configuring steps per unit and units per in Mach 3 - can anyone help?
« Reply #11 on: December 31, 2013, 03:37:35 PM »
If your system specs are the same as the OP posted then it would be
200 x 8 x 20 =32,000 steps per unit.
Hood
Logged

Offline gnomic

*
  • 2 2
Re: Configuring steps per unit and units per in Mach 3 - can anyone help?
« Reply #12 on: April 21, 2014, 07:16:21 PM »
Trying to set up steps. Units set to inches. If I put in 1" it moves about 1/20. If I put in 20 it moves one inch? Yes I am a moron. Any info. Appreciated.
Logged
Pages: « 1 2   Go Up
« previous next »