I was wondering if anyone has made a Plugin for the Microkinetics MN400 Controller?

Would like to use the controller I have but willing to switch to a breakout board.

If No plugin is Available anyone recommend a Breakout Board?

Will be using the Microkinetics Drive Rack With the DR8010 Drivers?

Photo Of My 12X36 CNC Project Lathe Attached!

I have never heard of a plugin for that controller I am afraid.

What exactly does it consist of and how does it connect to the computer? What I am getting at is, is it connected via the parallel port or is it  a PCI card or USB or possibly Ethernet?
Hood

It connects via USB or Serial... http://www.microkinetics.com/index.php?page=motionc

I am seriously thinking of just getting a breakout board and wiring it up to simplify things.

Any recommendations on a breakout board I will need 3-axis ?

Ok, you would definitely need a plugin to use the original hardware in that case.

Regarding a breakout board, I always used to use  PMDX breakouts, they are excellent quality and have never heard of anyone with a problem.

Hood

Thanks will be looking into a plugin are there any tech doc's for a place to start?

There used to be a SDK on the Artsoft site but not sure where on the new site it is located.

There is a plugin section on the forum, you may get help there.
You will find it here
http://www.machsupport.com/forum/index.php/board,28.0.html

Hood