Hello Guest it is October 31, 2024, 07:58:53 PM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: FileIn ?  (Read 9130 times)

0 Members and 1 Guest are viewing this topic.

Offline rainnea

*
  • 16 16
FileIn ?
« on: January 25, 2009, 04:12:37 PM »
What's the correct usage of FileIn ?

I'd like to use this instead of calling a subprogram if that's possible?

thanks,
Rab
www.cnc-toolkit.com
Logged

vmax549

*
Re: FileIn ?
« Reply #1 on: January 25, 2009, 05:35:19 PM »
Hiya Rab, Are you working in VB or Gcode?

(;-) TP
Logged

Offline rainnea

*
  • 16 16
Re: FileIn ?
« Reply #2 on: January 26, 2009, 05:10:18 AM »
This is in gcode.
I'm sure that I had this working a few years ago but can't remember the formating,
I'm currently using P1 to call subprograms (O1....M99) but these are getting very long.

Rab
Logged

vmax549

*
Re: FileIn ?
« Reply #3 on: January 26, 2009, 10:32:06 AM »
There is no FILEIN command that I am aware of in MACH Gcode. (;-) Just the old SUB routine M98P1 ---o1,M99.

Hope that helps,(;-) TP
Logged

Offline rainnea

*
  • 16 16
Re: FileIn ?
« Reply #4 on: January 26, 2009, 11:36:12 AM »
It may have been a vb command but called from within a gcode file ?

Rab
Logged

Offline rainnea

*
  • 16 16
Re: FileIn ?
« Reply #5 on: January 26, 2009, 06:33:07 PM »
Where can I download the latest Mach / VB documentation ?
thanks,
Rab
Logged

vmax549

*
Re: FileIn ?
« Reply #6 on: January 26, 2009, 07:02:30 PM »
THe mach manual is on the Documentaion page and the VB script manual is in the Mach WIKI. There is a link to the manual there.

I don't see mention of the command FILEIN in either. BUT I do recall the filein from another controller language , I think AHHA. I have seen it before somewhere other than in MACH.

(;-) TP
Logged
Pages: 1   Go Up
« previous next »