New problem

Pages: 1 Go Down

0 Members and 1 Guest are viewing this topic.

« on: July 15, 2006, 11:40:54 AM »

Attached is my .Tap file (very simple) Gcode cause it to cut inside instead of outside. What am i doing wrong.

leg part 2.dxf (90.3 kB - downloaded 458 times.)

leg part 23.tap (0.61 kB - downloaded 427 times.)

Logged

« Reply #1 on: July 15, 2006, 12:49:05 PM »

will it work if you change the G41 to a 42?

Logged

Fixing problems one post at a time

« Reply #2 on: July 16, 2006, 04:52:57 AM »

Hi,

I have a similar problem but only on the outside chain. See attached example (I've tested an other part but the result is the same)

Jean-Louis

test.dxf (14.62 kB - downloaded 361 times.)

test.tap (1.21 kB - downloaded 368 times.)

Logged

Jean-Louis

« Reply #3 on: July 16, 2006, 10:54:40 AM »

I think there is a problem with the Comp (G42 or G41) that is getting called

This is not a simple problem and will take some time to fix.
Thank you
Brian

Logged

Fixing problems one post at a time

Pages: 1 Go Up