Hello Guest it is May 12, 2025, 07:13:40 PM
Profile Guest
« previous next »
Pages: « 1 2   Go Down

Author Topic: Code hangs and z drils to China  (Read 14850 times)

0 Members and 1 Guest are viewing this topic.

Offline Hood

*
  • 25,835 25,835
  • Carnoustie, Scotland
Re: Code hangs and z drils to China
« Reply #10 on: December 21, 2008, 04:04:56 PM »
Oh meant to add that you seem to have the Z Axis homing in the negative direction, unless your machine has some special kind of setup then that should be reversed to Home positive.
Hood
Logged

vmax549

*
Re: Code hangs and z drils to China
« Reply #11 on: December 21, 2008, 04:38:06 PM »
IN Your file that line 4910 is acutally line 491 that is where mach will stop if the license file is not active for some reason. Might want to double check . You will also see an error around line 6810 where there is an error with radius end point not same as starting point on the next line(;-).

Just a thought, (;-) TP
Logged

Offline Hood

*
  • 25,835 25,835
  • Carnoustie, Scotland
Re: Code hangs and z drils to China
« Reply #12 on: December 21, 2008, 04:44:56 PM »
Chip
 Think you need must have your IJ mode as Abs
Hood
Logged

Offline citadelcomputer

*
  • 7 7
Re: Code hangs and z drils to China
« Reply #13 on: December 21, 2008, 08:22:42 PM »
We used the xml files off the dyna setup disc. Sorry, but were a little confused and new to this. Are these settings in mach or sheetcam? Is g4 set in sheetcam or mach 3? Thanks for the help.
Logged

Offline Chip

*
  • *
  • 2,055 2,055
  • Gainesville Florida USA
Re: Code hangs and z drils to China
« Reply #14 on: December 22, 2008, 12:36:58 AM »
Hi, Citade

The G4 setting is in Mach3 Config, General Configuration, See Pic below.

Thanks, Chip
Logged
Pages: « 1 2   Go Up
« previous next »